GB
General notice (liability): the details of this technical documents serve for description. Consents regarding the availability of certain features or
regarding a certain purpose always require a special written agreement.
Page 15 GB 7.3 - 7.4 Right reserved to make technical changes!
7.3 Fault Display
7.4 Deactivating the refrigeration unit
In case of longer periods of non-use or maintenance and
cleaning, deactivate the refrigeration unit by pulling the
plug. A short deactivation of the refrigeration unit can be
initiated by pushing the Start/Stop button
(StandBy Mode).
The refrigeration unit and the other users connected to it
are still connected to the electrical power supply while in
StandBy mode.
Note:
In case of loss of power, all the parameter settings are
retained.
Display Meaning
F01 Short-circuit in room sensor
F02 Room sensor broken
F03 Pressostat fault
F04 Coldroom temperature too high
F05 Coldroom door open
F06 Coldroom temperature too low
F07 Refrigeration capacity too low
F08 Evaporator sensor faulty
F09 Condenser sensor faulty
F10 Emergency Switch ON
F11 Fault in EEPROM
To Next Page
Loading...
