What to do if the Viessmann Vitocom 100 yellow LED is permanently on?
If the yellow LED on your Viessmann Remote Control is permanently on, it means that a dial-in to the GSM mobile phone network was not possible within 2 minutes. You should check the aerial position. If that doesn't work, trigger a reset by briefly pressing the pushbutton for entering the PIN and make another attempt to dial in.
What to do if no dial-in to GSM mobile phone network possible with Viessmann Remote Control?
If you're experiencing issues with dialing into the GSM mobile phone network using your Viessmann Remote Control, there are a couple of things you can try. First, check the SIM card by testing it in a mobile phone and ensure the aerial is correctly positioned. If the issue persists, try performing a reset by briefly pressing the button and then attempt to dial in again.
What to do if Viessmann Recording Equipment flashes red quickly?
If the operating status indicator on your Viessmann Recording Equipment flashes red quickly, it indicates an internal fault with the Vitocom 100. To attempt a fix: * Disconnect the plug-in power supply unit and reconnect it after approximately 15 seconds. * If the problem continues, consider replacing the Vitocom 100.
Why does Viessmann Recording Equipment flash green for too long?
If the operating status indicator on your Viessmann Recording Equipment flashes green for longer than 5 minutes after start-up, it indicates a fault when initialising the Vitocom 100. To resolve this: * Disconnect the plug-in power supply unit and reconnect it after approximately 15 seconds. * If the issue persists, replace the Vitocom 100.
What to do if Viessmann Recording Equipment mobile network connection flashes yellow?
If the mobile network connection status indicator on your Viessmann Recording Equipment flashes yellow slowly, it means a connection to the mobile network cannot be established. Here's how to address it: 1. Use a mobile phone to check the reception quality of the mobile network where the aerial is installed. 2. Adjust the aerial. 3. Select a different site for the Vitocom 100. 4. Use a tested SIM card for another mobile network.
Why is the mobile network connection status indicator yellow on my Viessmann Recording Equipment?
If the mobile network connection status indicator on your Viessmann Recording Equipment illuminates yellow, it means the wireless connection is not available. To solve this, disconnect the plug-in power supply unit and reconnect it after approximately 15 seconds. This will repeat the connection attempt.
How to fix red flashing light on Viessmann Recording Equipment reception quality indicator?
If the reception quality indicator on your Viessmann Recording Equipment flashes or illuminates red, it indicates inadequate reception quality. To resolve this: * Check the mobile network reception quality using a mobile phone where the aerial is installed. * Adjust the aerial. * Consider selecting a different site for the Vitocom 100 and the aerial.
Operating Environment| operating ambient temperature | 32°F to 131°F (0°C to +55°C) |
|---|---|
| storage and transport ambient temperature | -4°F to 185°F (-20°C to +85°C) |
| installation locations | living spaces and boiler rooms |
Power| operating voltage | 5V– |
|---|---|
| rated current | 1.6 A |
| power consumption | 8 W |
Plug-in Power Supply| rated voltage | 120V~ |
|---|---|
| rated frequency | 60 Hz |
| output voltage | 5V– |
To Next Page
