ViewLight CSO SL-9900 - Page 21

INSTRUCTIONS FOR USE
EN
31/52
LED LAMPS OPERATING ALARM (68) ON SLIT LAMP BASE
FAULT EFFECT CAUSE ACTION
1
Base LED (68)
u;;m-Ѵ-v
on
Powered base.
Powered LED-holder.
White light emission
-Ѵ|Ŋ=u;;or;u-ঞomĺ
Projector LED
2
Base LED (68)
!;71omঞmo-
vѴ
White power LED in
the LED-holder is not
powered or maximum
or;u-ঞm]|;lr;u-|u;
was exceeded.
"b|1_o@ķ-b|=ou
the red LED to turn
o@ĺ_;1h1omm;1ঞom
between base and
LED-holder. Restore
-m7vb|1_0-1homĺ
Projector LED
)_b|;-Ѵ-v
OFF
3
Base LED (68)
Red LED emits two
;t-ѴY-v_;vrѴv
one pause.
The +5V of the control
card in the LED-holder
is missing.
"b|1_o@ķ1_;1h
1omm;1ঞomv0;|;-
en the base and the
Ŋ_oѴ7;uķŐ-Ѵvo
bmvb7;|_;Ŋ_oѴ7;uķ
]u;;mo@őĺ
Restore and switch
0-1homĺ
Projector LED
m|;ulb;m|_b|;
LED
4
Base LED (68)
-v|bm|;ulb;m|
Red LED (approx. 2
pulses per second)
Input voltage exceeds
maximum voltage
"b|1_o@ĺ!;71;
input voltage to
below maximum
oѴ|-];ķŐƐƑ(-1ƳƒƏѷőķ
as measured on the
0-v;bmr|1omm;1|ouķ
m-l;ѴƐƔĺѵ(-1ĺ
$um0-1homĺ
Projector LED
m|;ulb;m|_b|;
LED
5
Base LED (68)
"Ѵobm|;ulb;m|
Red LED (approx.
ƐrѴv;;;uƒ
seconds.)
Input voltage is lower
than the required
voltage
"b|1_o@ĺm1u;-v;
input voltage to above
lbmblloѴ|-];ķ
ŐƐƑ(-1ŊƐƏѷőķ
as measured on the
0-v;bmr|1omm;1|ouķ
m-l;ѴƐƏĺѶ(-1ĺ
$um0-1homĺ
Projector LED
m|;ulb;m|_b|;
LED
6
Base LED (68)
m|;ulb;m|
Orange and Green
vķƑrѴv;vrѴv
one pause
Base or LED-holder
o|r|ro;uvrrѴ
+5V in short-circuit.
"b|1_o@ķ;Ѵblbm-|;
short-circuit and turn
0-1homĺ
Projector LED
White LED with
minimum intermit-
|;m|-Ѵ;Ĺ
7
Base LED (68) "|;-7u-m];
White LED in shor-
tcircuit
"b|1_o@ķu;lo;
short-circuit and turn
0-1hom
Projector LED )_b|;o@