ViewLight CSO SL-9900 - 5.2. Fault Messages

30/52
INSTRUCTIONS FOR USE
EN
5.2. FAULT MESSAGES
FAULT EFFECT CAUSE ACTION
1
LED on
Lamp OFF
-bmvvm1_uombv-ঞom
failure and/or internal
o;u_;-ঞm]
2
"Ѵobm|;ulb;m|
LED (1Hz)
Lamp ON
PCB (Printed Circuit
Board) input voltage is
low (below 5.8 V CA)
PCB input voltage is too
low (below 5.5 V CA
3
"Ѵobm|;ulb;m|
LED (5Hz)
Lamp OFF
PCB input voltage is
high (over 15 V CA)
4
m|;ulb;m|
Ő7o0Ѵ;ŊY-v_bm]ő
Lamp OFF
Output current to the
lamp is high (approx.
4 A)
5
m|;ulb;m|
Ő|ubrѴ;ŊY-v_bm]ő
Lamp OFF
|r|oѴ|-];
-7fv|l;m|bv
bm1omvbv|;m|
Analogical fault – ADC
v-|u-ঞomŐ-m-Ѵo];|o
7b]b|-Ѵ1om;u|;uőĸ
$_;Ѵ-lrbvor;u-ঞm]
bm|u-mvr-u;m|lo7-Ѵb|
(unregulated).