ViewSonic CDP4260-L - PIP Menu; CONFIGURATION1 Menu

18
4.2.4. PIP menu
PIP
1
2
3
SET EXIT MENU
PIP
:SEL :NEXT
PIP MODE
PIP SIZE
PIP AUDIO
PIP H POSITION
PIP V POSITION
SUB INPUT
PIP RESET
PIP
:RETURN :EXIT MENU
SMALL
MAIN AUDIO
100
0
VIDEO
OFF
PIP MODE
Select the PIP (Picture-in-Picture) mode.
The options are: {OFF} / {PIP} / {POP} / {SBS
ASPECT} / {SBS FULL}.
PIP SIZE
Select the size of the sub picture in the PIP
(Picture-in-Picture) mode.
The options are: {SMALL} / {MIDDLE} / {LARGE}.
PIP AUDIO
Select the audio source in the PIP (Picture-in-
Picture) mode.
• {MAIN AUDIO} - Select audio from the main
picture
• {SUB AUDIO} - Select audio from the sub
picture.
PIP H POSITION
Adjust the horizontal placement of the sub picture.
PIP V POSITION
Adjust the vertical placement of the sub picture.
SUB INPUT
Select the input signal for the sub-picture.
PIP RESET
Reset all settings in the PIP menu to factory preset
values.
NOTES:
• The PIP function is available only for certain
signal source combinations as shown in the
table below.
• The availability of the PIP function will also
depend on the resolution of the input signal
being used.
Main Picture
Sub Picture
DVI VGA HDMI YPbPr Video DP
DVI XOXOOX
VGA OXOXXO
HDMI XOXOOX
YPbPr O X O X X O
Video O X O X X O
DP XOXOOX
(O: PIP function available, X: PIP function
unavailable)
By pressing the [PIP ON/OFF] button on the
remote control, you can change the mode in the
order shown below:
PIP POP
SBS ASPECT SBS FULL
OFF
The resolutions in the PIP and POP modes are
FRQ¿JXUHGDVIROORZV
PIP SIZE {SMALL} : 320 x 240 pixels
{MIDDLE} : 480 x 320 pixels
{LARGE} : 640 x 480 pixels
POP SIZE: 474 x 355 pixels
NOTE: The images displayed in the sub picture
DOZD\V¿WWKH3,3VL]HVVKRZQDERYH
irrespective of the aspect ratio of the input
image.
4.2.5. CONFIGURATION1 menu
PIP
1
2
3
SET EXIT MENU
1
:SEL :NEXT
OFF TIMER
SCHEDULE
DATE AND TIME
CONFIGURATION1 RESET
CONFIGURATION1
:RETURN :EXIT MENU
OFF
OFF TIMER
Set the display to turn itself off to standby mode
ZLWKLQDQDPRXQWRIWLPHVSHFL¿HG
The options are: {OFF, 1HOUR ~ 24HOURS} from
currrent time.
SCHEDULE
This function allows you to program up to 7 (seven)
different scheduled time intervals for the display to
activate.