Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this unit near water.
6. Clean with a soft, dry cloth.
7. Do not block any ventilation openings. Install the unit in accordance with
the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers,
stoves, or other devices (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type
plug. A polarized plug has two blades with one wider than the other.
A grounding type plug has two blades and a third grounding prong. The
wide blade and the third prong are provided for your safety. If the
provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at
plugs. Convenience receptacles and the point where they exit from the
unit. Be sure that the power outlet is located near the unit so that it is
easily accessible.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table
specified by the manufacturer, or sold with the unit.
When a cart is used, use caution when moving the
cart/unit combination to avoid injury from tipping over.
13. Unplug this unit when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required
when the unit has been damaged in any way, such as: if the
power-supply cord or plug is damaged, if liquid is spilled onto or objects
fall into the unit, if the unit is exposed to rain or moisture, or if the unit
does not operate normally or has been dropped.
LS810/LS820/LS830_QSG_Rev. 1a 06-14-17
Copyright © 2017 ViewSonic Corporation. All rights reserved.
2 3 41
5
Screws: M4 x 8 (Max. L = 8 mm)
Unit: mm
100-240 Vac
50/60 Hz
There is 3% tolerance among these numbers due to optical component variations. It is
recommended that if you intend to permanently install the projector, you should
physically test the projection size and distance using the actual projector in situ before
you permanently install it, so as to make allowance for this projector's optical
characteristics. This will help you determine the exact mounting position so that it best
suits your installation location.
LS810 LS810
LS820/LS830 LS820/LS830
LS810/LS820/LS830
DLP Projector
Quick Start Guide
http://vsweb.us/ls810
http://vsweb.us/ls820
http://vsweb.us/ls830
http://vsweb.us
Projector Distance Projector Expert
UG Link
V
iewSonic
3
To Previous Page
Loading...
