To Next PageTo Next Page
Need help?Do you have a question about the ViewSonic PJD6251 and is the answer not in the manual?
General| Number of colors | 16.78 million colors |
|---|---|
| Projection distance | 1 - 10 m |
| Vertical scan range | 50 - 120 Hz |
| Horizontal scan range | 31 - 100 kHz |
| Projection technology | DLP |
| Contrast ratio (typical) | 2800:1 |
| Screen size compatibility | 40 - 300 \ |
| Projector native resolution | XGA (1024x768) |
| Keystone correction, horizontal | 40 ° |
| Digital zoom | 1.2 x |
| Focal length range | 19.9 - 23.88 mm |
| I/O ports | 2 × 15-pin mini D-sub 1 × 15-pin mini D-sub 1 × RCA jack 1 × 4-pin mini-DIN |
| Audio input | 2 × 3.5mm mini jak |
| Aspect ratio | 4:3, 16:9 |
| RS-232 ports | 1 |
| Dimensions (WxDxH) | 280 x 218 x 114 mm |
| Power requirements | AC 100-240 V, 50 - 60 Hz, 2.5A |
| Lamp power | 230 W |
| Light source type | Lamp |
| Service life of light source | 4000 h |
| Analog signal format system | SECAM |
| RMS rated power | 5 W |
| Number of built-in speakers | 2 |
| Serial interface type | RS-232 |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| VGA (D-Sub) ports quantity | 3 |
| Color depth | 24 bit |
| Certification | CB, ROHS, WEEE, UL/cUL, FCC-B, ICES-003, IRAM (Argentina), NOMPSB, C-tick, EK, CE, TUV/GS, GOST-R, Hygienic, SASO UKrSEPRO, CCC |
| Power consumption (standby) | 1 W |
| Power consumption (typical) | 380 W |
| Storage temperature (T-T) | -20 - 60 °C |
| Operating temperature (T-T) | 0 - 40 °C |
| Operating relative humidity (H-H) | 30 - 85 % |
| Product type | Standard throw projector |
| Market positioning | Presentation |
Weight and Dimensions| Weight | 2900 g |
|---|
Provides essential safety guidelines for operating the projector, including water, heat, and cord handling.
Lists maximum concentration values for hazardous substances in compliance with RoHS Directive.
Explains the LEDs and buttons on the projector's control panel.
Identifies and describes all input and output terminals on the projector.
Instructions for turning the projector on and off, including warm-up and cool-down cycles.
Details adjustments for brightness, contrast, color, keystone, and aspect ratio.
Guides on connecting the projector to a network and setting up IP addresses (DHCP/Manual).
Explains how to access and log into the projector's web-based control interface.
Details settings for network parameters like IP, Subnet Mask, Gateway, and DHCP.
Covers controlling projector settings like Power, Input Source, Picture, and Volume via the web.
Details the process and precautions for replacing the projector lamp.
Provides solutions for common startup, image, and remote control problems.
