ViewSonic va1616w-8 - Gain Adjustment; Geometry Adjustment

- 25 –
Set the Contrast to 70，Adjust the Brightness to 100.
5.) Gain adjustment :
Move cursor to “-F-” and press MENU key
A、Adjust 9300 color-temperature
(1)、Switch the CA-210 to x、y、Lv -Mode (with press “MODE” button )
(2)、Switch the MEM. channel to Channel 1 ( with up or down arrow on CA-210 )
(3) 、 The LCD-indicator on CA-210 will show x=0.283±0.003, y=0.298±0.003,
Lv≥147cd/m
2
(4) Adjust the R G B of color3 on factory window until CA210 indicator reached
x=0.283±0.003, y=0.298±0.003, Lv≥147cd/m
2
B、Adjust 6500 color-temperature
(1)、Switch the CA-210 to x、y、Lv -Mode (with press “MODE” button )
(2)、Switch the MEM .channel to Channel 1 ( with up or down arrow on CA-210 )
(3) 、 The LCD-indicator on CA-210 will show x=0.313±0.003, y=0.329±0.003,
Lv≥179cd/m
2
(4) Adjust the R G B of color3 on factory window until CA210 indicator reached
x=0.313±0.003, y=0.329±0.003, Lv≥179 cd/m
2
C、Adjust 5400 color-temperature
(1)、Switch the CA-210 to x、y、Lv -Mode (with press “MODE” button )
(2)、Switch the MEM .channel to Channel 1( with up or down arrow on CA-210 )
(3) 、 The LCD-indicator on CA-210 will show x=0.335±0.003, y=0.350±0.003,
Lv≥168 cd/m
2
(4)、Adjust the R G B of color3 on factory window until CA210 indicator reached
x = 0.335±0.003; y = 0.350±0.003; Lv≥168 cd/m
2
D、Adjust SRGB color-temperature
(1)、Switch the CA-210 to x、y、Lv -Mode (with press “MODE” button )
(2)、Switch the MEM .channel to Channel 1 ( with up or down arrow on CA-210 )
(3) 、 The LCD-indicator on CA-210 will show x=0.313±0.003, y=0.329±0.003,
Lv≥179 cd/m
2
(4)、Adjust the R G B of color3 on factory window until CA210 indicator reached
x=0.313±0.003, y=0.329±0.003, Lv≥179 cd/m
2
F、Press reset key and Turn the Power-button “off to on” to quit from factory mode。
2. Geometry
1).Set cross-hatch pattern and preset timing as timing table listed.
2).Change to each mode in turn and wait for the monitor finish auto-alignment and save
press before change to next mode.
3).Until all of modes are adjusted, exit OSD menu and press POWER OFF to exit factory
mode.