ViewSonic VP171s - Function Test and Alignment Procedure

5-6.1 All Modes Reset
You should do All Mode Reset (Refer to Chapter 5-3) first.
This action will allow you to erase all end-users settings and restore the factory defaults.
5-6.2 Auto Image Adjust
Please select and enter Auto Image Adjust function on Main Menu to see if it is workable. The Auto Image
Adjust function is aimed to offer a better screen quality by built-in ASIC. For optimum screen quality, the user has
to adjust each function manually.
5-63 Firmware and DDC
Test Pattern: Burn In Mode (Refer to Chapter 5-3)
- Make sure the F/W is the latest version.
- Make sure the S/N is the same as the Spec. label.
- Make sure the model name is correct.
5-6.4 Fine Tune and Sharpness
Test Signal: 1280*1024 @60Hz
Test Pattern: Line Moire Pattern
- Check and see if the image has noise and focus performs well.
eliminate visual line bar.
- If not, readjust by the following steps :
(a) Select and enter Fine Tune function on Manual Image Adjust to adjust
the image to eliminate visual wavy noise.
(b) Then, select and enter Sharpness function to adjust the clarity and focus
of the screen image.
5-6.5 Boundary
Test Signal : 1280*1024@60Hz
Test Pattern : Horizontal & Vertical Line Thickness Pattern
- Check and see if the image boundary is within the screen frame.
- If not, readjust by the following steps :
(a) Select and enter Manual Image Adjust function on OSD Main Menu.
(b) Then, select and enter Horizontal Size or Horizontal/Vertical Position
function to adjust the video boundary to be full scanned and within screen frame.
Function Test and Alignment Procedure
ViewSonic Corporation
36
Confidential – Do Not Copy
VP171/b/s
5-6