Viking Electronics E-10-IP - Programming Features

Programming Features
To Program the E-10/20/30/32-IP Phone... Step 1 Step 2
...to store 555-1234 as the first emergency speed dial
number
Enter Programming
(see A. Accessing the Touch Tone
Programming Mode, page 10)
Enter digits:
5 5 5 1 2 3 4 # 0 0
...to clear the first emergency speed dial number
Enter Programming
(see A. Accessing the Touch Tone
Programming Mode, page 10)
Enter digits:
# 0 0
A. Speed Dial Numbers (memory locations #00 - #04)
Note: Up to 32 digits can be stored in each dial position via touch tone programming, up to 90 characters via PC program-
ming. Touch tone
Q and # count as single digits.
The speed dial number programmed in location #00 is the number that is dialed when
the ”CALL” button is first pressed. Additional speed dial numbers will be dialed when
there is no answer or a busy signal is detected and the next number redial features are
activated. To program, enter the desired speed dial number followed by the location
number (#00 - #04). To clear a speed dial location, simply enter the memory location
(#00 - #04) alone. The E-10/20/30/32-IP phone is factory set with no speed dial number
programmed.
To Program: Enter:
QQQ
#
Q#
0, 1, 2 .... 9 0, 1, 2 .... 9
B. Speed Dial Programming Examples
This feature selects switching time between talk and listen modes (VOX switching time).
Use chart at the right.
* Note: The factory default is .5 seconds.
2. Talk / Listen Delay (VOX) (#11)
This feature selects the maximum length of time that calls can be connected. Program-
mable in increments of 1 minute up to a maximum of 9 minutes (Touch Tones 1 - 9). Pro-
gram 0 in this location to disable the call length time out. With the call length disabled, the
E-10/20/30/32-IP phone must rely on a CPC signal, busy signal, silence or return to dial
tone to hang-up. Use chart at the right.
* Note: The factory default is 3 minutes.
3. Call Length Time Out (#12)
Touch
Tone
Talk/Lis-
ten Delay
1 .1 sec
2 .2 sec
3 .3 sec
4 .4 sec
5 .5 sec *
6 .6 sec
7 .7 sec
8 .8 sec
9 .9 sec
Touch
Tone
Call Length
Time Out
0 Disabled
1 1 min
2 2 min
3 3 min*
4 4 min
5 5 min
6 6 min
7 7 min
8 8 min
9 9 min
1. Speed Dial Numbers (#00 - #04)
12