22 EN
Refrigerator / User Manual
6. Mantenance and cleanng
Servce lfe of the product extends and frequently faced
problems decrease f cleaned at regular ntervals.
WARNING: Unplug the product before
cleaning it.
• Never use gasolne, benzene or smlar substances for cleanng
purposes.
• Never use any sharp and abrasve tools, soap, household
cleaners, detergent and wax polsh for cleanng.
• Dssolve one teaspoon of bakng soda n half lter of water. Soak a
cloth wth the soluton and wrng t thoroughly. Wpe the nteror
of the refrgerator wth ths cloth and dry thoroughly.
• Make sure that no water enters the lamp housng and other
electrcal tems.
• If you wll not use the refrgerator for a long perod of tme,
unplug t, remove all food nsde, clean t and leave the door ajar.
• Check regularly that the door gaskets are clean. If not, clean
them.
• To remove door and body shelves, remove all of ts contents.
• Remove the door shelves by pullng them up. After cleanng,
slde them from top to bottom to nstall.
• Never use cleanng agents or water that contan chlorne to clean
the outer surfaces and chromum coated parts of the product.
Chlorne causes corroson on such metal surfaces
Avodng bad odors
Materials that may cause odor are not used in the production of
our refrigerators. However, due to inappropriate food preserving
conditions and not cleaning the inner surface of the refrigerator
as required can bring forth the problem of odor . Pay attention to
following to avoid this problem:
• Keepng the refrgerator clean s mportant. Food resduals,
stans, etc. can cause odor . Therefore, clean the refrgerator
wth bakng soda dssolved n water every 15 days. Never use
detergents or soap.
• Keep the food n closed contaners. Mcroorgansms spreadng
out from uncovered contaners can cause unpleasant odors.
• Never keep the food that s past ts expraton date or has spoled
n the refrgerator.
Protectng the plastc surfaces
Do not put lqud ols or ol-cooked meals n your refrgerator n
unsealed contaners as they damage the plastc surfaces of the
refrgerator. If ol s splled or smeared onto the plastc surfaces,
clean and rnse the relevant part of the surface at once wth
warm water.