Why are the igniters sparking on my Viking CRVDR3302 Ranges but there is no flame ignition?
If the igniters are sparking but there's no flame ignition, the gas supply valve might be in the “OFF” position, or the gas supply could be interrupted. Ensure the gas supply is on.
What to do if the igniters will not work on my Viking Ranges?
If the igniters on your Viking Ranges won't work, the circuit may be tripped, a fuse may be blown, or the range might not be connected to power. Check these possible issues.
Why is the flame large, distorted, or yellow when the burner ignites on my Viking Ranges?
If the burner ignites but the flame is large, distorted, or yellow, the burner ports may be clogged, the unit might be operating on the wrong type of gas, or the air shutters may not be properly adjusted.
Why are the igniters sparking continuously after flame ignition on my Viking CRVDR3302?
If the igniters are sparking continuously after flame ignition, the power supply may not be grounded, the power supply polarity may be reversed, or the igniters may be wet or dirty. Check these potential issues.
Why is there a strong odor and/or smoke when I use my Viking Ranges oven for the first few times?
A strong odor and/or smoke noticed during the first few uses of the oven is normal. It is due to the burn-off of insulation and protective oils. This will go away after using the oven a few times.
Why will the oven light not work on my Viking CRVDR3302 Ranges?
If the oven light will not work, it could be that the light bulb is burned out, or the range is not connected to power. Check these possible issues.
To Next Page
General