615
Continuous Drain 5. Check for leaks:
(Con’t) 5a. At door 5a. Plum and square dishwasher
5b. Lens cover for interior light 5b. Replace lens mount and lens
5c. Hoses and loose clamps 5c. Tighten fittings or advise customer to contact
installer or plumber. (Recommend using an
original hose clamp and crimping tool)
6. Timer motor may have stalled 6a. Replace timer
7. Timer may be misaligned to 7a. Align timer
causing timer to freeze up
when cycling.
Rapid timer advance 1.Faulty timer 1a. Replace timer
2.Under carriage full of water 2a. (See continuous drain)
Excessive water in tub 1.Check when float switch is 1a. Replace float switch
activated 2a. Check for leak in hose
Interior too hot or melt- 1. Element shaped incorrectly 1a. Bend element down in high areas
ing silverware container 1b. Replace element
and rack
2. Temperature switch out of 2a. Remount temperature switch
bracket or temperature switch 2b. Replace faulty temperature switch
remaining closed beyond high 2c. Replace damaged parts
limit.
Film on dishes 1. Water contains too many
minerals. 1a. Notify customer
2. Unit reusing old water or 2a. Drain system clogged - clear drain
(See continuous drain)
3. Open drain pump 3a. Replace drain pump
4. Water not hot enough 4a. Heater coil open, fractured wire
5. Detergent dispenser tank
empty or valve not opening 5a. Check continuity to detergent dispenser
Base pan area full of (See continuous drain)
water
Not drying dishes 1. Ventilator air fan malfunct- 1a. Check air flow through ventilator at bottom of
ioning door.
2. Blower fan not working 2a. Replace blower fan / check wiring
3. Solenoid open for circulating
air flow. 3a. Check continuity / replace solenoid
4. Heating element open 4a. Replace heating element.
Power supply: Always disconnect unit from power before servicing. NEVER ASSUME: 1) Unit voltage has been disconnected. Check line
voltage at dishwasher. 2) Breaker will remain off during service - anyone at anytime for any reason may turn breaker on, take precautions,
especially when other workers are on job site.
Mounting Problems: Always mount and secure dishwasher square and plum
Drain: Always use same size drain hose and connectors and do not detach drain hose from upper back mount.
Fill: Run fill line clear of all mechanisms and electrical connections. It is not recommended to use a metal braided fill hose.
Interior: Lime or mineral deposits can be cleaned with General Electric dishwasher lime and mineral cleaner.
Door: When removing door be cautious of wire length to door switch. Too much pull on the door switch wire can cause door switch to brake in
half or come free of holding bracket.
To Next Page
Loading...
