623
DFUD042 / DFUD142
CHANGING A PROGRAM AFTER THE UNIT HAS STARTED
The dishwasher is programmed to stop operating if the door is opened during
a cycle. If you want to change a program or option after starting the machine,
open the door slightly to let the spray arms stop rotating and avoid getting
sprayed with water. Press and hold START for three (3) seconds to cancel the
current selection then press the touch pad(s) for your desired selection. Press
Start again and close the door. The drain pump will run to remove any dirty
water from the dishwasher before starting the newly selected cycle. Check to
make sure there is still detergent in the detergent dispenser.
WHEN THE WASH IS FINISHED:
The indicator lights will come on for the last wash program and options that
you used. (NOTE: The unit will not retain the Rinse/Hold or Quick program.)
To Next Page
Loading...
