Viking DFUD040 - Page 26

625
Fault Tracing: Press TEMP (6) five times
and then:
1) Press Normal (2) to start Inlet Valve
2 (Not on all models)
2) Press China (3) to start Inlet Valve 1
3) Press Rinse (4) to start
Combination Dispenser
4) Press Econo (5) to start Heater
5) Press Temp (6) to start Circulation
Pump
6) Press Heat Dry (7) to start Drain
Pump (and Fan/Vax motor VUD040)
7) Press Delay (8) to start Fan/Vax
Motor (not DFUD040)
Press Start/ Stop to exit Fault Mode.
Drain Time Adjustments: Press China
(3) five times to Enter Reprogramming
Mode.
1) Press China (3) to get 20 seconds
Drainage Time
2) Press Rinse (4) to get 25 seconds
Drainage Time
3) Press Econo (5) to get 35 seconds
Drainage Time.
4) Press Temp (6) to get 45 seconds
Drainage Time.
5) Press Heat Dry (7) to get 85 seconds
Drainage Time.
Extra Rinse: You can get an extra rinse
in the programs, Pots, Normal and China
by doing this:
1) Press Normal (2) five times within 15
seconds. Then you get into the
changing program. The program will
show how
many rinses the machine last
gave, and you get an extra rinse or
press Rinse and you get the normal
number of rinses.
Fault Tracing: Press TEMP (6) five times
and then:
8) Press Normal (2) to start Inlet Valve
2 (Not on all models)
9) Press China (3) to start Inlet Valve 1
10) Press Rinse (4) to start
Combination Dispenser
11) Press Econo (5) to start Heater
12) Press Temp (6) to start Circulation
Pump
13) Press Heat Dry (7) to start Drain
Pump (and Fan/Vax motor VUD040)
14) Press Delay (8) to start Fan/Vax
Motor (not DFUD040)
Press Start/ Stop to exit Fault Mode.
Drain Time Adjustments: Press China
(3) five times to Enter Reprogramming
Mode.
6) Press China (3) to get 20 seconds
Drainage Time
7) Press Rinse (4) to get 25 seconds
Drainage Time
8) Press Econo (5) to get 35 seconds
Drainage Time.
9) Press Temp (6) to get 45 seconds
Drainage Time.
10) Press Heat Dry (7) to get 85 seconds
Drainage Time.
Extended Fan Cooling: You can
cool down the washing items under
30 minutes after heated drying by
the fan cooling. Press Econo (5) for
extended fan cooling.
1) Press Pots (1) five times within
15 seconds. Then you get into the
changing program.
2) Press Rinse (4) and you get 30
minutes extra fan cooling, or
press China and you get the
normal fan cooling.
Geographical location of switches on the
keyboard. (Some switches are not
displayed on some models.)