Viking Stack-Rack - User Manual

Figure 1
Step 2: Rack Assembly
Position the port and starboard brackets onto the center of
the cooler rack rear tube as shown in figure 2. Attach the
brackets using two 8mm x 55mm hex bolts, washers and
locknuts. Finger tighten only. Attach this assembly to the
column tube at the desired position and secure using one
10mm x 70mm hex bolt, washer and locknut as shown in
Figure 3. Tighten securely, then reverse the nut until the
brackets rotate freely on the column tube. Now securely
tighten the two 8mm x 55mm bracket bolts.
Step 1: Attaching Column Tube to the Receiver Tube
The Column Tube is attached to the Receiver Tube
using one 12mm x 80mm hex bolt, flat washer and
locknut, and the 12mm curved clevis pin. Attach the
Column Tube as shown in figure 1. Tighten the
12mm hex bolt securely, then reverse the nut until
the column tube is free to rotate.
Stack-Rack
Vertical Receiver Mounted Cargo Rack
Assembly and Use Instructions
Assembly Tools Required:
Adjustable Crescent Wrench
13mm Box Wrench or Socket
16mm Box Wrench or Socket
18mm Box Wrench or Socket
Stack-Rack Parts Overview
General Purpose
Rack
Port Mounting
Bracket (2)
Column Tube
Tie-Down Rings
Receiver Tube
Starboard Mounting
Bracket (2)
Cooler Rack
Receiver Tube
Column Tube
12mm x 80mm Hex Bolt
8mm x 55 mm
Hex Bolt
Figure 3
Step 3: Repeat Step 2 for the general
purpose rack. Position the general purpose
rack at the desired location on the column
tube and secure using the same procedure in
Step 2.
10mm x 70mm
Hex Bolt
Receiver Clevis
Pin Hole
Figure 2
12mm Clevis Pin & Cotter Pin
12mm Washer and
Locknut this side
10mm Washer and
Locknut this side
Port Bracket
Starboard Bracket

Summary

Stack-Rack Assembly

Attaching Column Tube to Receiver Tube

Attaches the column tube to the receiver tube using a 12mm hex bolt, washer, locknut, and clevis pin.

Rack Assembly

Positions and attaches port/starboard brackets to the cooler rack rear tube and column tube.

General Purpose Rack Assembly

Repeats Step 2 for the general purpose rack assembly on the column tube.

Viking Stack-Rack Usage Instructions

Set-up and Operation

Guides initial setup and operational procedures for the Stack-Rack, including hitch insertion and cargo loading.

Folding Access to Cargo;Truck Bed

Details how to pivot the Stack-Rack away from the vehicle for improved access to the cargo area.

Viking Stack-Rack Specifications

General

Brand	Viking
Model	Stack-Rack
Category	Automobile Accessories
Language	English