Viking SwiveLift User Manual

Figure 1
Step 2: Roller Bracket Assembly
Position the two roller brackets onto the end of
the lift beam as shown in figure 2. Attach the
brackets using two 10mm hex bolts, washers
and locknuts. Insert the plastic rollers as
shown and secure using two 12mm hex bolts,
washers and locknuts. Do not overtighten so
the rollers may rotate freely.
Step 1: Attaching the Lift Beam to the Lift Platform
The lift platform is attached to the lift beam using
two 10mm hex bolts, two flat washers and two
locknuts. Attach the lift platform as shown in figure
1. Tighten the hex bolts securely.
SwiveLift
Receiver Mounted Lifting Platform
Assembly and Use Instructions
Assembly Tools Required:
Adjustable Crescent Wrench
14mm Box Wrench or Socket
16mm Box Wrench or Socket
18mm Box Wrench or Socket
SwiveLift Parts Overview
Hand Winch
Lift Platform
Column Tube
Lift Beam
Receiver Tube
Assembly
Roller Bracket (2)
Plastic Rollers (4)
Lift Platform
Lift Beam
10mm Hex Bolt
10mm Hex Bolts
12mm Hex Bolts
Plastic Rollers
Figure 3
Step 3: Attaching the Hand Winch
Position the hand winch onto the end of the column tube as shown in
figure 3. Attach the winch using two 8mm hex bolts, washer and
locknuts and tighten securely. The washer and locknut should be
inside the tube. Note: the winch spool should be near the end of the
tube.
Hand Winch
Column Tube
8mm Hex Bolt
Clevis Pin Hole
Figure 2

Viking SwiveLift Specifications

General

Brand	Viking
Model	SwiveLift
Category	Automobile Accessories
Language	English

Summary

SwiveLift Receiver Mounted Lifting Platform Assembly

Step 1: Attaching the Lift Beam to the Lift Platform

Attaches the lift beam to the lift platform using two 10mm hex bolts, two flat washers, and two locknuts.

Step 2: Roller Bracket Assembly

Attaches roller brackets to the lift beam using 10mm hex bolts and plastic rollers with 12mm hex bolts.

Step 3: Attaching the Hand Winch

Secures the hand winch to the column tube using two 8mm hex bolts, washers, and locknuts.

Set-up and Operation of the SwiveLift

Step 1: Receiver Hitch Installation

Insert receiver tube assembly into a 2" Class III/IV hitch and secure with a locking clevis pin.

Step 2: Platform and Column Assembly

Place lift platform over pivot tube and slide column tube over pivot tube until seated against receiver assembly.

Step 3: Winch Cable Attachment

Attach winch cable hook to the lift ring of the lift platform assembly for raising/lowering.

Step 4: Raising and Lowering Loads

Use hand winch to raise/lower platform. Secure loads with tie-down straps before moving.