Villager VBV 230 E

To Next Page

To Previous Page

Villager

VBV 230 E (GB)

Arrowhead on the

valute case

Arrowhead on the

blower nozzle pipe

Fig 3

Fig 4

Fig 5

ASSEMBLING THE BLOWER

1. With the air vent closed, push the straight nozzle pipe over the discharge port

and locking pin, the arrowhead on the straight nozzle pipe should be on the same

line with the volute case. Rotate the pipe clockwise to lock. Then tighten the screw

in place to secure (Fig.3).

2. Tighten the screw in place to secure

(Fig.4).

3. Push the blower nozzle pipe over the

straight nozzle pipe and locking pin. Rotate

the pipe clockwise to lock. The side of the

blower nozzle pipe that says “THIS SIDE

UP”must face upwards. Then tighten the

screw in place to secure (Fig.5).

Villager VBV 230 E - Page 26