12
BLOWER MODE
Before operating the unit,check for the following:
The operator is wearing proper clothing, eye and ear
protection.
All blower attachments are properly installed and
secure.
1. Start the unit.
2. Direct the nozzle in the direction in which to blow
(Fig.16).
3. Pull the throttle control.
4. Set the throttle lock at any desired speed by pushing
the knob to the lock position. To adjust throttle speed,
push the throttle lock to the off position, adjust,and
relock the throttle control.
VACUUM
Before operating the unit, check for the following:
All vacuum attachments are properly installed and secure.
Make sure Mulch Collection Bag is not twisted or constricted in any way.
1. Start the unit.
2. Place collection bag strap over the left shoulder and adjust the strap as
necessary (Fig.17).
3. Pull the trigger to start the vacuum.
4. Set the throttle lock at desired speed.
5. Empty the bag as necessary by removing it from
unit and opening the zipper located at the top edge.
NOTE: Do not operate this unit with the cage side up
or the handle side down.
When operating the unit for collecting, if the entrance of the collecting
pipe is jammed with lots of leaves, do slow down the engine speed,
and then make the pipe clean immediately, or else it will damage your
machine seriously.
To Next Page
Loading...