Vimar ELVOX 41001 - Page 24

The standard LEDs instead indicate in which conguration you
are selecting by pressing
(OK).
The correspondence is as follows:
LED conguration Meaning (Parameter)
Selecting order of pushbutton
modules
Pushbutton remapping
Automatic procedure for assigning
indoor unit ID
Automatic procedure for assigning
speech unit ID
Lock time
Conversation time
Audio level
Reset factory settings / Restart /
External Memory Reset
Default pushbutton grouping
Pressing the
button (DEL) at this level sets it back to rest.
Press
(OK) to enter the specic conguration.
Conguration
The electronic module is congured via the “SaveProg” system
software.
However, some parameters can be modied via the electronic
module itself, using the 4 standard buttons and their 4 indicator
LEDs, or with the LCD when installed. In some cases the but-
tons and LEDs of the additional modules are used too.
Conguration input
The procedure is activated, from the state of rest of the speech
unit, by pressing and holding the
button for 5 s. After this
time the speech unit will emit a tone. Release the
button
and, within 30 s, press the sequence of buttons forming the
password. The timeout is renewed each time the button is
pressed, so there are 30 s from the tone after which the speech
unit goes back to rest.
By default the password is:
Activation is conrmed by a tone.
To navigate in choosing the time to be congured, only the 4
standard buttons are used; the numbering and the function of
the buttons is as follows:
PREVIOUS: to return to the previous
sequence.
NEXT: to move on to the next sequence.
DEL: to exit the configuration menu or a
configuration editing phase, cancelling the
selected one.
OK: to go from the sequence menu to
configuration editing or to confirm the change to
a configuration.
24
41001 - 41002 - 41003 - 41004
EN