Vimar SW24.T User Manual

9
SW24.T
Remote control programming
Note: remote control programming can only be done with the automatic gate system stationary
Step-by-step programming
No. Pressing push button Signal PRG LED Description
1 MRX O󰀨 Press the MRX push-button and hold it down until the green PRG LED starts ashing slowly
2
Remote control push-
button
Slow blink Press the remote control push-button that you want to save
3 -
Fixed 1 s Button of the saved remote control (new remote control)
3 blinks Memory full
Programming the second radio channel
No. Pressing push button Signal PRG LED Description
1 MRX O󰀨 Press the MRX push-button and hold it down until the green PRG LED starts ashing fast
2
Remote control push-
button
Fast blink Press the remote control push-button that you want to save
3 -
Fixed 1 s Button of the saved remote control (new remote control)
3 blinks Memory full
Deleting a remote control
No. Pressing push button Signal PRG LED Description
1 MRX O󰀨
Press the MRX push-button and hold it down until the green PRG LED starts ashing very
fast
2
Remote control push-
button
Very fast ashing Press the button on the remote control to delete
3 - Fixed 1 s Deletion successful
Complete deletion of the receiver
No. Pressing push button Signal PRG LED Description
1 - O󰀨 Remove power from the control panel and disconnect any batteries
2 MRX On steady
Reapply power to the control panel without releasing the MRX button until the PRG LED
turns o󰀨
3 - O󰀨 Receiver deleted completely
Note:after deleting all the remote controls, the rst saved remote control congures the control panel to accept only remote controls with a
rolling code or only remote controls with a xed code.
EN

Vimar SW24.T Specifications

General

Brand	Vimar
Model	SW24.T
Category	Control Unit
Language	English