Vincent
37
OPERATING THE APPLIANCE
Operation Button(s) Description
Switch on and off
POWER (2)
The DAC is switched on and off using this button at the front panel. After
switching on, the device needs up to 30 seconds before it is ready to ope-
rate.
Select input source
SELECT
(3) (18)
With this button, you can select between four input sources (AES/EBU,
USB, Coaxial IN and Optical IN). By pressing this button, the player
changes to the playback of the device connected thereto.
Switch between tube
amplification and
transistor amplification
TUBE/FET
(5)
This switch allows you to choose if the converted music signal that is read
from the CD is amplified to the output level using the internal TUBE amplifier
or the internal FET transistor amplifier. This selection can only be made on the
front panel.
Volume of the connected
headphones (7)
LEVEL (7)
This function can only be operated on the front of the device. Turn the dial
“LEVEL” clockwise to increase the volume in the headphones and anticlockwi-
se to reduce the volume. This volume control has no effect on the output level
of the analogue “ANALOG OUTPUTS” (8) on the back of the device.
Mute the DAC
MUTE (17)
The MUTE function can be activated with the remote control (17). It switches off
the outputs (8).
To Next Page
Loading...