Zenitel Norway AS and its subsidiaries assume no responsibilities for any errors that may appear in this
publication nor for damages arising from the information in it. No information in this publication should be
regarded as a warranty made by Zenitel Norway AS.
The information in this publication may be updated or changed without notice. Product names mentioned in
this publication may be trademarks and are used only for purposes of identication.
Zenitel Norway AS ©2011
About this Document
Document Scope
This document is intended for qualied technicians who will install and
service the VSP 12 Way Amplied Batteryless Telephone System on
marine vessels.
The document provides relevant information on system features,
available equipment, typical congurations, simplied wiring and
programming, and technical data for the system.
Interconnection procedures, hardware requirement and special terminal
programming for conguration are also described.
The following station models (version 6.0) are available for the VSP 12
Way system:
Product Part Number
Main Station, panel mounted VSP-211-L
Main Station, panel mounted with relay circuit VSP-223-L
Main Station, watertight VSP-122
Main Station, portable, watertight VSP-122P
Main Station, panel mounted, indoor unit VSP-213-L
Publication Log
Rev. Date Author Comments
4.0 2008-04-23 Published
5.0 2009-08-24 SEN/JF
New circuit board
Some contents updates
New document layout
5.1 18-05-2010 HKL Complete DIP switch settings
5.5 30-08-2010 ER
New front and back page.
Doc. no. VSP-12 Way_is is
replaced by A100K10873
6.0 22-7-2011 HKL
Version 6.0 station models,
revised block diagram
6.1 16-5-2012 HKL Revised block diagram
Related Documentation
For further information about the VSP Amplied Batteryless
Telephone System not covered by this manual, refer to the following
documentation:
Doc. no. Subject Documentation
A100K10675 VSP 12 Way Amplied Batteryless Telephones Getting Started Guide
A100K10758 VSP-M Amplied Batteryless Telephones Technical Manual
VSP-Ex_iu Intrinsically Safe Set for VSP
VSP-5012 Buffer unit & VSP-512 Main station
Installation & User
Manual