INSTALLING THE HANDLE
This wine cooler includes a stainless handle that is not required to operate this unit. To install the handle please
follow the below instructions:
① Pull away the door gasket in the area where the handle is to be
installed. You can see two designated holes for handle installation.
The gasket is easily displaced by hand, no tools are necessary.
② Install the handle tightly as shown below with the two screws,
lock washers and flat washers provided. (DO NOT over tighten as
this will cause damage to the handle assembly and stainless steel
surface of the glass door).
③ Replace the door gasket to its original position.
OPERATING YOUR WINE COOLER
The controls of your wine cooler
The wine cellar should be placed in an area where the ambient temperature range is between 18-26 degrees.
If the ambient temperature is above or below this range, the performance of the unit may be affected. For
example, placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate.
Upper Zone: 5-22°C (41°F - 72°F), Lower Drawer: 1-8°C (34°F - 46°F)
To Next Page
Loading...
Need help?
General
