To Next Page
D
David CoxSep 1, 2025
What causes wine to divide in a Vinotemp VT-WINEDISP2 Beverage Dispenser?
- DDavid JenkinsSep 1, 2025
If the wine is divided in your Vinotemp Beverage Dispenser, clean out any debris.
What causes wine to divide in a Vinotemp VT-WINEDISP2 Beverage Dispenser?
If the wine is divided in your Vinotemp Beverage Dispenser, clean out any debris.
What causes a Vinotemp VT-WINEDISP2 compressor to run but not cool?
If your Vinotemp Beverage Dispenser's compressor is running but not cooling, check for any restrictions and see if the fan is turning.
What to do if the temperature is too low in my Vinotemp VT-WINEDISP2 Beverage Dispenser?
If the temperature of your Vinotemp Beverage Dispenser is too low, insert the sensor in a cup of iced water to see if it displays 32°F. Unplug the unit to defrost it. If needed, change the power board or the display/control board.
How to lower the temperature on my Vinotemp Beverage Dispenser?
If the temperature of your Vinotemp Beverage Dispenser is too high, lower the temperature setting. Also, make sure the temperature sensor is not touching the cold panel.
Why is my Vinotemp VT-WINEDISP2 Beverage Dispenser making noise?
To address noisy operation in your Vinotemp Beverage Dispenser, ensure the unit is level and on a flat, solid surface. Check if the noise comes from the fan mount, compressor mount, or loose tubing. Inspect the blade clearance. Determine if the fan blade is broken or if the motor is making noise.
Why is my Vinotemp Beverage Dispenser running at a high temperature?
If your Vinotemp Beverage Dispenser is running at a high temperature or continually, check the door opening and gasket. Also, check the installation location, the fan and its clearance.
What to do if my Vinotemp VT-WINEDISP2 Beverage Dispenser is not dispensing?
If the Vinotemp Beverage Dispenser is not dispensing, and none of the spouts dispense wine, check the canister pressure gauge or turn the canister slightly counterclockwise to see if any gas escapes. Turn clockwise to re-tighten. Then, check for gas leaking. If the canister has pressurized gas, check the regulator. Press the dispense button to check if gas is escaping from the plug or fixer and to see if gas is escaping out of the gas tube. Switch the questionable valve to a working spout to check to see if problem still exists. Check all wirings and connections.
General| Brand | Vinotemp |
|---|---|
| Model | VT-WINEDISP2 |
| Category | Beverage Dispenser |
| Language | English |
Prepare the wine dispenser by removing packaging and cleaning the exterior.
Place the unit on a solid, level surface with adequate clearance for proper circulation.
Steps for installing and removing the argon/nitrogen gas cartridge for operation.
Procedure for cleaning the stopper dispenser and solenoid valve using warm water.