Vinotemp VT200 - Page 7

ENTRUCTIONS FOR CORRECT AND EFFICIENT USE
• THE WINE CELLAR requires a power supply of 115 VAC and
60Hz. Make certain that you connect the CELLAR to a proper
voltage supply.
• THE DIGITALLY CONTROLLED TEMPERATURE SYSTEM WILL
AUTOMATICALLY MAINTAIN the proper storage temperature for
different wines: red wines are stored in the upper section of the
cabinet, and white wines are stored in the lower section. Two
arrows can be found in the inner cabinet: “ red wine ” with upward
arrow and “ white wine ” with down ward arrow.
• Temperature indication: On the control panel, you can find two
indicators: upper one marked “R” is for red wine, and “ W”
is for white wine. The temperature for each zone will be
displayed as follows: when the upper indicator on LED displays
the temperature for red wine zone; for white wine zone
temperature, the lower indicator will be on. When the actual
cabinet temperature is lower than 22° F, the LED will display
“ LL” ; when it is higher than 99° F, “ HH ” will be displayed in
the LED; when there may be a power disruption the panel will
display “ER” .
• Temperature setting:
The temperature pre-set by the manufacturer is 55° F average.
When it is pre-set, the upper section temperature is higher than
the lower section accordingly. Five seconds after setting, the LED
will show the actual cabinet temperature. After the machine has
been working for 24 hours, the temperature of the inner cabinet
will be relatively balanced.
Re-setting by user:
When the cellar is initially connected to the power, press the “set”
button. The LED will display the factory pre-set temperature of
55° F and the white wine indicator is on. If you wish to re-set the
5
VT200050802VT-V6