Vinotemp VT200 - Packaging and Transportation.7; Cautions for Operation.7

PACKAGING AND TRANSPORTATION
• When unpacking unit for inspection, make certain that all parts
are placed in their original position for re-transporting to further
destination.
• Do not lay WINE CELLAR on its side. The angle between the
cabinet and the ground should not be less than 45 0 .
• Do not handle or lift the CELLAR by its door.
• Collision and violent vibrations should be avoided during
moving and transportation.
CAUTIONS FOR OPERATION
• When using CELLAR for the first time or after it has been
moved, wait for 30 minutes before plugging in to avoid
damage to the compressor.
• After removing the power plug from the outlet, wait 5 minutes
before plugging CELLAR in again to avoid damage to the
compressor.
• Make certain the WINE CELLAR is plugged into an approved
circuit or outlet. To prevent accidents, do not use in an
overloaded circuit or outlet. The electrical outlet should have
proper ground fault protection.
• Do not use this WINE CELLAR if electrical supply outlet is
questionable or does not conform to these instructions.
• Use caution on the electrical cord to prevent the insulation from
damage and do not place weight on the electrical cord.
Consumers should not attempt to use an extension cord to
connect power to the unit. Please contact a qualified electrician
to have it replaced in accordance with applicable electrical
codes.
• Remove all packaging prior to using the WINE CELLAR to
VT200050802VT-V6