www.whisperkool.com | Page 13
Alarm
The alarm symbol is shown when the cooling sytem encounters an issue that needs
attention, the displayed alarm codes are explained below. The alarm code will remain
displayed until corrected.
Alarm Codes
CPSM (Customer Preference Selection Mode)
Message Cause Solution
“E1”
Faulty bottle probe
Loose connection
1. Replace bottle probe.
2. Check connection at the circular connector and at the back of the controller.
“HA”
The bottle probe is sensing
a temperature that is 10°
above the set point
1. Allow time for the wine to reach the desired temperature.
2. Make sure doors are closed and have a proper seal.
3. Follow the procedures in the pre-installation instructions to test the unit for proper
cooling.
“LA”
The bottle probe is sensing
a temperature that is 10°
below set point.
1. Make sure unit is not in cooling mode. (the snowake symbol will not be lit.)
2. Add heat to the cabinet until the wine reaches the desired temperature.
Press and hold the set button for approximately 5 seconds to enter the CPSM menu.
Use the down arrow to access the following parameters.
PA2
No adjustable settings in this parameter.
tab
No adjustable settings in this parameter.
Rel
No adjustable settings in this parameter.
loc Change this parameter from “n” to “y” to lock the keyboard from changes to the set point.
To Next Page
Loading...