VintageView W Series Single

To Next Page

W Series

Installation Instructions for W Series Single (WS-LEFT & WS-RIGHT)

• 1 “Single” Rack

• 2 Screws

• 2 Toggle Bolts

• 2 Mounting Hole Caps

• Phillips head screw driver

• Level

• Pencil

• Tape Measure

• Drill

Parts List Required Tools

Side Note:

Concrete, Brick or Stucco: 3/16” x 1 ¼” masonry screw or #8 x 1 ¼ inch screw with appropriate size

expanding concrete anchor - not included

Figure A

Figure B

1. Mark the mounting hole locations – (See

image below) to ensure appropriate minimum clearance

around the Single and hold the rack against the wall.

Use a level to ensure the rack is horizontal and mark the

mounting hole locations on the wall.

2a. Drill anchor holes for drywall – Drill

1/16 in pilot holes to determine if the holes are over

a stud. Drill ½ in (13.7mm) hole for the Toggle Bolts

centered on the marked hole locations.

2b. Install into wood – use a screw to fasten

the strip into the wood/stud at mounting point.

Need help?

Do you have a question about the VintageView W Series Single and is the answer not in the manual?

VintageView W Series Single Specifications

General