EasyManua.ls Logo

VIOMI V3 - Common Errors

VIOMI V3
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Left ground sensor fail
Front ground sensor fail
Right ground sensor fail
Left collision sensor fail
Left wheel stuck
Right wheel stuck
Left wheel fail
Right wheel fail
Suction fan fail
Side brushes fail
Robot stuck
Solenoid valve abnormality
LED flash 1 times
LED flash 2 times
LED flash 3 times
LED flash 5 times
ED flash 6 times
ED flash 7 times
LED flash 8 times
LED flash 9 times
LED flash 10 times
LED flash 11 times
LED flash 13 times
LED flash 15 timesDustbox not installed
Troubleshooting
Please put the machine on the flat ground and wipe the
left ground sensor
Please place the machine on a flat surface and wipe the
front ground sensor
Please put the machine on the flat ground and wipe the
right ground sensor
Right collission sensor fail LED flash 4 times
Check the right part of front cover stuck or not
Check the left part of front cover stuck or not
Check if the left wheel is wrapped or stuck
Check if the right wheel is wrapped or stuck
Dust-absorbing motor abnormal, please check the
dust-absorbing motor
Check whether the left and right side brush has
been twined
The robot is trapped, please move the robot to a new
position and start again
LED flash 14 times
The solenoid valve is abnormal, please check the wiring;
whether the water tank is installed properly
Left wheel abnormal, please check the wiring
Right wheel abnormal, please check the wiring
Put the Dustbox back
Tips:
If you can't rule out the corresponding faults by referring to the above methods,
please contact our customer service in time.
9. Common Errors
Under the fault state, the machine will stop working. Automatic LED, LED light of fixed time will
flash at the same time, the buzzer will make an alarm. The alarm instructions are as follows.
20
Fail mode Failure reminding

Other manuals for VIOMI V3

Related product manuals