To Next Page
S
sandraturnerAug 3, 2025
Why is my VIPool MJB output weak?
- EEdward RaymondAug 4, 2025
If your VIPool Swimming Pool Pump has weak output, several factors could be responsible. The prefilter might be clogged, so cleaning it is a good first step. An air leak along the suction pipe could also be the culprit; in this case, check the condition of the couplings and seals. For three-phase motors, an incorrect motor revolution direction can cause this issue; inverting two phases on the electricity supply may resolve it. Pressure loss in the suction can also lead to weak output; avoid long or narrow pipes, numerous elbows, and positioning the pump higher than the water level. Finally, ensure the voltage in your supply corresponds to the value specified on the motor data plate.
General