• The airflow to the router is from the top surface near the Viptela logo. To ensure that the airflow to the
router is not blocked, keep an air gap of 2-3 inches (5-8 cm) above the router and do not place anything
directly on top of the router.
• Avoid temperature extremes. Ensure that the router is operating at an ambient temperature not more that
40°C (104°F) at sea level. For higher altitudes, a derating of 1.5°C per 1,000 feet applies.
• High humidity conditions can cause moisture to penetrate into the chassis. The device supports 10% to
85% humidity levels, noncondensing.
Install the vEdge 100wm Router
Once you have prepared your site for router installation, unpack the vEdge 100wm router and install the SIM
card and the antennas before you mount the router on the wall.
Unpack the vEdge 100wm Router
A vEdge 100wm router is shipped in a cardboard carton and is secured firmly in place with foam packing
material. The carton contains a packing list and Quick Start instructions. It is recommended that you not
unpack the router until you are ready to install it.
To unpack the router:
1. Open the top flaps of the carton.
2. Gradually remove the packing foam holding the router and the accessories in place. See Figure 1.
3. Take out the router and each accessory.
4. Verify the router components against the packing list included in the box (see packing list below).
Figure 1: Unpacking the vEdge 100wm Router
vEdge 100wm Router
13
vEdge 100wm Router
Install the vEdge 100wm Router
To Next Page
Loading...
Need help?
General
