16
Your Super Hub allows you to easily
change some of the more commonly
used functions of your home network,
such as SSID (your wireless network
name), Passphrase (security password),
‘Auto detect’ or ‘Manually set’
(wireless channel) and WEP/WPA/
WPA2 (security encryption type).
To access/change your Super
Hub settings you need to do
the following:
If you wish to change your Super Hub
settings you should access the Super
Hub Settings area.
Step 1
Open your internet browser and enter
http://192.168.0.1 into the address
bar and the following screen will
appear:
Step 2
You are prompted to enter your ‘Super
Hub Username’ and ‘Super Hub
Password’. These can be found on the
label on the back of your Super Hub
under ‘Super Hub settings’.
Wireless Network Settings
The Wireless Network Settings area
will allow you to change the following
settings:
Wireless on/off
This allows you to enable or disable
the wireless function of your Super
Hub. Disabling this will prevent any
devices connecting wirelessly.
Security mode
This allows you to change the wireless
security encryption used by your Super
Hub. This defaults to WPA Auto, which
allows WPA and WPA2 (higher
CHAnGInG your
Super Hub SettInGS
113775_VM_Super Hub_MainGuide_AW02.indd 16 29/10/2010 10:50
To Next Page
Loading...
Need help?
General
