EN
Virtufit Premium Trampoline with Safety Net
16
• Install the bottom of enclosure net to the jumping mat as below 3 steps.
• Locate the D-ring closest to the door of the net. Thread one end of the cord through the lower eyelet
of the enclosure net above the D-ring and then thread the cord through the D-ring. Tie the enclosure
net to the D-ring, by making a double knot in the cord.
• Thread the cord through the lower eyelet of the enclosure net halfway between the first D-ring and
the D-ring to right, and then thread the cord through to the right. Repeat this procedure until the
cord are threaded through the enclosure net.
• Tie the cord to the last D-ring that is reaches. Make sure that the enclosure net is attached to every
D-ring on the trampoline mat.
ASSEMBLY INSTRUCTIONS
To Next Page
Loading...