7
Viscount Chorale 3Owner’s Manual
6. [ENC] piston: pressing this piston activates the Enclosed function used to control the organ’s general
volume using the swell pedal [SWELL].
N.B.
When the Enclosed function is activated, the volumes of the Great and pedal board are immediately
set in relation to the position of the [SWELL] swell pedal. When the Enclosed function is deacti-
vated, the volumes of the above sections are immediately reset in relation to the position of the
[GREAT / PEDAL] swell pedal.
7. [T] piston: piston used for switching the Tutti on and off.
The voice composition of the Tutti function is programmable. To set a new configuration, switch on
the stops and couplers of your choice, press [S], keep it pressed and then press the [T].
8. [C] piston: Cancel piston, which switches off all the stops, tremolos and pistons under the Choir
active, then resets the general HRs.
2.3 THE SIDE PANELS
Other organ controls such as the volume controls, reverb adjustment and the graphic display showing all
the instrument’s main setup and adjustment functions are located on the right and left of the manuals, in
easy reach of the organist.
To make use of these controls quicker and easier, all the rotary trimmers are on the left of the manuals,
with the graphic display and the relative control buttons on the right.
LEFT PANEL
MAN.IPEDAL
REVERB
POWER
GENERAL
1 2
3 4
5
1. [GENERAL] trimmer: regulates the organ’s general
volume.
2. [REVERB] trimmer: regulates the level of the reverb digital
effects.
3. [PEDAL] trimmer: pedal board volume.
4. [GREAT] trimmer: Great volume.
5. [POWER ] Switch: the switch used to switch the organ on
and off.
WARNING!
Do not switch the organ on and off in rapid succession. After the instrument is switched off, wait at
least 10 seconds before switching it back on.
GREAT
To Next Page
Loading...
