Viscount Maestro - User Effects for 1 St and 2 Nd Parts

Viscount Maestro – Grande - Sinfonia
56
6.2. USER EFFECTS FOR 1ST AND 2ND PARTS
In the following table you will find a list of the effects that you can set separately
on the 1ST and 2ND parts, using the C.EFF.2 button.
N
o.
EFFECTS DESCRIPTION PARAM.1 PARAM.2
1 Mono Phaser cyclically changes the signal phase,
modulating the sound
Rate Emphasis
2 Stereo Phaser same as above, with stereo input Rate Emphasis
3 Chorus (*) typical modulation
that conveys a natural spatiality
Rate Depth
4 Flanger chorus with an added resonance
that modulate the timbre
Rate Resonance
5 Tremolo (**) cyclic level modulation Speed Depth
6 Vibrato cyclic phase modulation
that shifts the sound pitch
Speed Depth
7 Vibrato Scanner vibrato effect
typical in drawbar organs
Mix Depth
8 AutoPanPot cyclically moves the sound image
in the stereo field (L-R-L-R-L-...)
Speed Depth
9 Cross Panner like AutoPanPot,
with stereo input,
so that L and R channels
cyclically swap
Speed Depth
1
0
Rotary Speaker rotating loudspeaker simulation,
mostly used with drawbar organs
Hi Speed Lo Speed
(*) same effect as the one related to the CHORUS button on the panel
(**) same effect as the one related to the TREMOLO button on the panel
NOTA BENE:
you can have a section effect for the 2ND part only, when playing
XG timbres: this means that the selected section effect for 1ST part will be enabled only
if a Viscount timbre plays on that part. Moreover, the ‘Rotary Speaker’ effect is available
only on 1ST part, whatever timbre is selected.