VisioFocus mini 06700 - 5. Room Temperature; 6. Memory Function; 7. How to Change the Settings

7
wait 30 min. before taking another reading.
Proceed as you would for a forehead reading but press the “home”
button; the
projection will appear on the surface and the light of the “home” button will turn on.
After the measurement, the projection of the temperature value will remain visible for
about 12 seconds. During this time, should you nd it dicult to see the temperature
value, (as in the case of transparent, too dark or irregular surfaces, such as bathwater,
wine, soup) then, once the button is released, you may address the projection on ano-
ther light and opaque surface. You will not need to respect the correct distance from
the
surface: indeed in this case, the thermometer is not taking a temperature, but only
projecting the temperature value that has already been detected.
NOTE: this intended use is not subject to assessment by the Notied Body.
5. ROOM TEMPERATURE
The “Mem”
button lets you see the ambient temperature. Proceed as follows:
• Aim the device at any uniform and opaque surface.
• Press once the “Mem”
button: the projection will show the letter “A” (Ambient)
alternating with the ambient temperature value.
6. MEMORY FUNCTION
The «Mem”
button lets you call up the last 9 temperature readings.
Proceed as follows:
- aim the device at any uniform and opaque surface;
- press twice the «Mem”
button: the projection will show the number 1 in alterna-
tion to the last temperature taken. The light of the button which had been used for that
measur
ement (green for “face” or orange for “home”) will turn on.
If you push the button again before the memory’s light turns o: the number 2, alter-
nating with the second to last temperature taken will be projected, and the lightening
of the used button will tur
n itself on. And so on.
7. HOW TO CHANGE the SETTINGS
Depending on where it is to be sold, your thermometer leaves the factory as follows:
• preset to Celsius (°C) or Fahrenheit (°F)
• referred to oral (“Or”) or rectal (“rEc”) or axillary (“Ax”) or internal temperature readings
(“Cor”) or only internal temperature readings (no symbol shown).
If necessary, these settings can be modied as follows:
1. while the thermometer is o, aim the thermometer to any uniform surface;
2. press the “Mem”
button and hold it down; the projection will show the letter “A”