VisioFocus PRO 06480 - Foreword

2
INTENDED USE: VisioFocus
®
PRO is an infrared medical thermometer intended for
non-contact measurement of body temperature in children and adults (professional
use). It can also be used to monitor the temperature of inammations, ulcers, wounds
(e.g. on diabetics), internal organs during surgery or to detect the temperature of in-
travenous uid bags.
IMPORTANT: Each non-contact thermometer needs to be stabilized at the room tem-
perature. VisioFocus PRO is equipped with 2 quick calibration systems, which allow
the thermometer to quickly stabilize itself at the room temperature: the MQCS (Manual
Quick Calibration System) and the AQCS (Automatic Quick Calibration System). See
par. #8. Additionally, VisioFocus PRO foresees two dierent settings:
- “NURS” (default setting): the MQCS is requested and mandatory every 30 or 60
minutes, depending on the version. This setting is highly recommended for nurses
who take many measurements moving from room to room as well as for any intensive
use, such as in airports etc.
The “HOME”
button is disabled in “NURS” mode. The “Mem” button is di-
sabled and it can be enabled by changing the settings (see par. #7).
- “DOCT” mode: the MQCS is not mandatory, but if the thermometer’s temperature
is changing, the AQCS system is automatically activated and allows the rapid sta-
bilization of the thermometer at room temperature: the display shows a countdown
indicating the time required for its stabilization. To make a measurement it is necessary
to wait for the end of the countdown without touching the device. Alternatively, at any
time, it is possible to do the manual MQCS (suggested procedure).
Please note that if the thermometer set in “DOCT” is used too frequently and inten-
sively (as in a hospital department) the system will ask the user to make the MQCS
anyway (although with some delay).
In “DOCT” mode the “HOME”
and the “Mem” buttons are enabled.
To change the setting from “NURS” to “DOCT” – and vice-versa – see par. #7.
ATTENTION: in some versions the DOCT setting is disabled; to enable it write to info@
tecnimed.eu and specify the new use, the reason for change and the serial number.
1. FOREWORD
VisioFocus PRO is specically studied to be used in hospitals, ambulances or clinic
environments, but also airports, schools, factories, etc. in case of emergency and/or
pandemic situations where it is necessary to take several fast and hygienic tempera
-
ture readings. VisioFocus PRO is:
- hygienic: it never touches the patient, it does not need disinfection and does not
require expensive disposable caps;
- comfortable: as it is totally not invasive, there is no need to wake up the patient or to
ask for his cooperation while taking the temperature;
- accurate: detects the body temperature with constancy, repeatability and accuracy;