What to do if Vision Spirit G XL doesn’t startup after pressing the ON key?
If your Vision UPS doesn't start after pressing the ON key, make sure you are pressing the correct combination of keys simultaneously. Also, check the battery connection and voltage. If the battery voltage is low, turn off the UPS, remove some loads, and then try starting it again. If the problem persists, it may indicate an internal fault.
Why is the backup time so short on my Vision Spirit G XL UPS?
If your Vision UPS shows a short backup time, it could be due to several reasons. The battery might not be fully charged; in this case, keep the UPS connected to mains power for more than 8 hours to recharge it. Another reason could be that the UPS is overloaded. Check the connected devices and remove any unnecessary ones. Finally, the battery might be old. If you need to replace the battery, contact your supplier to get the correct battery and assembly.
What to do if the battery capacity indicator flashes on my Vision Spirit G XL?
If the battery capacity indicator on your Vision UPS is flashing, it means the battery voltage is low or the battery is disconnected. Check the UPS battery and ensure it is well-connected. If the battery is damaged, replace it.
Why is the “INPUT” flashing on my Vision Spirit G XL UPS display?
If the “INPUT” letters on the LCD display section of your Vision UPS are flashing, it indicates an incorrect connection of the mains live and neutral wires or that the mains power is out of the acceptable range. Reconnect the input power cable to ensure a correct connection.
What to do if Vision UPS has no input with normal mains?
If your Vision UPS has no input even when the mains are normal, it could be due to an open circuit in the UPS input breaker. Press the breaker to reset it.
Instructions for attaching rail assemblies to the front and rear of the rack.
Instructions for installing mounting brackets and securing the UPS in the rack.
Steps for wiring installation, including internal batteries and EBPs.
Connecting optional Extended Battery Modules (EBPs) to the UPS.
Steps for initiating the UPS startup sequence after installation.
Plugging EBP cables into the UPS battery connectors.
Description of the UPS control panel, LCD, and buttons.
Configuring the ECO (Economic) operating mode for the UPS.
Adjusting the bypass voltage settings for the UPS.
Steps for safely replacing UPS batteries.
Interpreting fault indicator lights, buzzer beeps, and required information for service.
To Next Page
General
