Vision V700-T20BJ - User Manual

Unitronics
1
Vision™PLC+HMI
Installation Guide
V700-T20BJ
V700-S-T20BJ
General Description
V700 PLC+HMI is programmable logic controller that comprise a built-in operating panel containing
a 7” Color Touchscreen
I/O Options
Snap-in I/O Modules / I/O Expansion Modules
Screen
7" Color Touch
Keypad or
Function Keys
None
Programming Com
Port, Built-in
RS232/485
Yes
Ethernet
Yes
USB device,
mini-B
Yes
Com Ports,
separate order,
installed by user
The user may install one or both of the following ports:
 CANbus port (V100-17-CAN)
 RS232/RS485 port (V100-17-RS4/V100-17-RS4X)
* V700 comprises both RS232/485 and USB ports; note that only one channel may be used at a time.
Standard Kit Contents
Controller
Yes
Terminal Block
Yes (3 pin)
Battery
Yes
Mounting Brackets
Yes (4 parts)
Rubber Seal
Yes
Alert Symbols and General Restrictions
When any of the following symbols appear, read the associated information carefully.
Symbol
Meaning
Description
Danger
The identified danger causes physical and property damage.
Warning
The identified danger could cause physical and property damage.
Caution
Caution
Use caution.
 Before using this product, the user must read and understand this document.
 All examples and diagrams are intended to aid understanding, and do not guarantee operation.
Unitronics accepts no responsibility for actual use of this product based on these examples.
 Please dispose of this product according to local and national standards and regulations.
 Only qualified service personnel should open this device or carry out repairs.
Failure to comply with appropriate safety guidelines can cause severe injury or property damage.
 Do not attempt to use this device with parameters that exceed permissible levels.
 To avoid damaging the system, do not connect/disconnect the device when power is on.

Summary

Alert Symbols and General Restrictions

Safety Symbols and Meanings

Explains danger, warning, and caution symbols and their meanings.

General Safety Guidelines

Provides critical safety precautions for product use and handling.

Environmental Considerations

Panel Mounting

Panel Cut-out Specifications

Defines the required panel cut-out size for controller installation.

Inserting the Battery

Wiring

Wiring Procedure Details

Power Supply

Earthing the PLC+HMI

Communication Ports

Pinouts

RS232 and RS485 Pinouts

RS232;RS485 DIP Switch Settings

Installing a Snap-in I;O Module

Module Installation Steps

Removing a Snap-in I;O Module

Module Removal Procedure

Vision V700-T20BJ Specifications

General

Screen Size	27 inches
Aspect Ratio	16:9
Response Time	5 ms
Brightness	250 cd/m²
Viewing Angle	178° (H) / 178° (V)
Panel Type	VA
Color Gamut	72% NTSC
VESA Mount	100x100 mm
Curved	No
Resolution	1920 x 1080
Contrast Ratio	1000:1
Connectivity	HDMI, VGA
Adaptive Sync	AMD FreeSync