VisionDrive VD-3000 - Page 4

1. Before use/caution
- This product shall be installed strictly inside a car following the informed procedure during
installation. Impurities on the car windshield can weaken the adhesive strength and can
damage the product if the product drops because of weak adhesion.
- This product is not water-proof. Be careful to avoid liquids or impurities entering the product.
- In case of cleaning the interior side of a car, do not use chemicals or detergents. These can
cause quality deterioration or errors to the vision drive.
- In case that there are impurities at the surface of a car window or at the surface of this
product camera, a distorted image can be obtained because of diused reection and
abnormal refraction. Windows and camera lens where camera is placed should be always
maintained to be clean.
- Be careful to prevent images of this product from being blurry or recorded images from being
distorted because of excessive window tinting on the windshield.
- Note that because this product uses a camera, recording can be distorted under the condition
that brightness suddenly changes e.g. passing through a tunnel or reverse light is too strong
during the day or there is no light at night.
- In case there is not enough lighting better images can be recorded if the user turns on the
lamps in the car.
- Note that data can not be stored in this product in case of accidents that the acceleration
impact is under a certain level. Manual recording to the [Event] folder can be done by pressing
the SHOT button in this case.
- Image data can be damaged if the user ejects the SD card in ON status of main power. Eject
the SD card after the main power is completely o.
- If you operate the product while driving, then it is risky, it can cause a car accident. Therefore,
the user should manipulate the product after fully stopping the car to a safe area.
- Dropping or giving an impact on the product during operation can cause errors or re.
- Do not keep the product under the environment conditions of too hot, too cold or too humid.
Distortion or errors can occur if the product is exposed to sunlight for long periods of time in
summer or left in a too cold area. Do not place the product close to re or expose to water.
Fire or serious errors can be caused.
- In case of disassembly of the product, the user shall disassemble it after complete power-o.
Disassembly with power-on status can cause errors of the product.