6. Installation sequence and procedure
6-1) Caution before installation
Check the cautions as follows before installation for safe installation and use.
- Install the product in a bright and safe area.
- Installation should be started after the car engine fully stops and car keys are ejected.
- The power cable of the Vision Drive should be connected at the end of installation.
- The product’s power shall be connected only to the cigar jack whose power ranges
from DC12V ~ DC 24V. The user shall consult or refer to the service center in case that
cable covering needs to be uncovered and connected to the car.
6-2) Installation sequence
1) Bracket and Vision Drive connection
2) Memory – Insert an SD memory card in Vision Drive
3) Vision Drive – Remove the double stick tape of the bracket and attach the bracket to the
front window
4) Cable – Connect the cables to the Vision Drive and arrange the cables
5) Power – Connect the cable between cigar jack and the product
6) Camera – Adjust the Vision Drive’s camera angle
7) Test – Test buttons (View/Shot/Play)
8) Operation – car operation and system operation
To Next Page
Loading...
