1
1. Description
3. Specification
4. Installation
The device is a standalone as well as a Wiegand access control keypad and
proximity card reader which supports EM, HID,and Mifare card types,it’s
one of the most advanced standalone access control .Its build-in USA Atmel
microprocessor,with strong anti-interference ability, high security and reliability,
powerful function and convenient operation.It is widely used in high-end buildings,
residential communities and other public places. This device can be used as standalone
and connected to a central Access Control Panel.
• Ultra-low power consumption: Standby current is less than 30mA.
• Input& Output: Wiegand26.
• Searching Time: Less than 0.1s after reading card.
• Backlight Keypad: Easy to operate at night.
• Doorbell interface: Support external wired doorbell.
• Access ways: Card, code, card+code.
• Independent codes: Use codes without related card.
• Change Codes: Users can change codes by themselves.
• Anti-tamper alarm: Alarm is activated after tear down illegally.
• Delete Users by card NO.: Delete card NO. by keypad to eliminate security risk
completely.
Install base plate onto wall and attach device using bottom screw
• Input Voltage: DC 12V
• Idle Current:≤25mA
• Card reading distance: 2-3 cm
• Card Frequency: 125KHz for EM and HID,13.56MHz for Mifare
• Card transmission format: wiegand26
• Keypad transmission format:4bit,8bit and Virtual card number
• Operating Temperature: -45°C~55° C (-49F – 131F)
• Operating Humidity: 0%~95%
2. Features
To Next Page
Loading...
