VisionTrack VT3000 - Page 8

VT3000 INSTALLATION GUIDE
7
VT3000 Specifications:
t +44 (0) 1246 225 745 | e orders@visiontrack.com | w visiontrack.com
GPS/BD dual mode
3G/4G
Video and Audio recording
Largest resource
Image setting
Video coding
Video compression rate
Audio compression standard
Audio compression ratio
Audio input
Sensor Type (VT-C26-IPC)
Sensor type (VT3000)
Shutter speed
Lens/FOV (field of view)
Lens interface type
Day-and-night switching mode
Day-and-night switching mode
Backlight compensation
Signal to noise ratio S/N
Infrared distance IR
Resolution ratio and frame
Rate of main code stream
Supports
Supports
Network
Positioning
Six-axis sensor
SD Card
The indicator light
shows the four states
of the device:
Supports
Power on: the device is powered, the red light is always on
Normal operation: green light is always on
Fault alarm: indicator red light flashes once a second
Sleep: green light flashes 1 second and off 10 seconds
SD card, supports SDXC64GB/128GB/256GB,
Supports hot plugging and unplugging
2 video channels, 2 audio channels
VT-C26-IPC: 720P @ 30fps
VT3000: 1080P @ 30fps
Main stream 1080P @ 30 frame +720P @ 30 frame,
2 way sub-stream VGA @ 30 frame
Brightness, color, contrast, color saturation,
H.264 baseline profile/H.264 main profile baseline
VT3000: 500Kbps ~ 6Mbps
VT-C26-IPC: 500Kbps ~ 6Mbps
G.711U/ADPCM
4:1
Supports
1/3" 1.23M pixel CMOS Sensor
1/2.9" 2M pixel CMOS Sensor
1/30sec - 1/100000sec
VT-C26-IPC: 2.3mm/115º (FOV); VT3000: 4mm/90º (FOV)
M12
VT-C26-IPC: supports; VT3000: doesn’t support
Digital wide dynamic
Supports
>48db
VT-C26-IPC: 3m; VT3000: none
Sensor
Storage
Video & Audio
Camera
parameters
Working
status
indicator
Dimensions
General
specification
Network Protocol
Operating temperature
HTTP, TCP, ARP, UDP, FTP, DHCP, DNS, IPV4, NTP
-30°C~+70°C
Storage temperature
Humidity
-40°C~+85°C
0% - 90%
LxHxW
90x39.5x100
Protocol
Power related
Power supply
Built-in battery
Typical power consumption
9-36V
Not supported
6W (up to 12W with 12v Power Output Option from GPIO Cable)
RS232
IO alarm
Speed
Power output
2 channels
2 with self-test
1 channel
5VDC @ 500mA, 12VDC @ 500mA
Interface