VX SERIES LED HEADLIGHT
SEE VEHICLE OWNERS MANUAL FOR HELP REPLACING HEADLIGHT
ADDITIONAL WIRING HARNESS ADAPTER MAY BE NEEDED CONSULT
YOUR DEALER TO DETERMINE IF ONE IS NEEDED
1. Disconnect vehicle battery prior to installation.
2. Review your vehicle manual for detailed instructions for
removing existing factory head light housing.
3. Remove Gore-Tex Valve Cover, prior to installation see
[Figure 1]
4. Attach VX Series LED Headlight to Optional HI-4 Module
(P–HLHI4), then to the existing factory plug and re-install
according to your vehicles manual. See [Figure 2]
5. To wire the LED Halo Daytime Running light, locate the
white wire on the back of the light. Power the white wire by
attaching it to the accessory power of the vehicle. If there
isn’t accessory power available ax it to the blue wire of
the light or its own aux switch.
WIRING INSTRUCTIONS XIL-7RDKIT
WIRING DIAGRAM
Red = High Beam [ + ]
Blue = Low Beam [ + ]
Black = Ground [ - ]
White = Halo [ + ]
WIRING KEY
white
black
blue
red
H4
Plug
OPTIONAL
P-HLHI4
Figure 2
To Next Page
Loading...