4
TECHNICAL
INFORMATION
Model:
FM3838BC
220-240V ~ 50/60Hz, 90W, Class II,
IPX4
CARE AND
MAINTENANCE:
This appliance is for household use only; there are no user serviceable
par
ts inside. Do not try
to
open or change the parts by yourself. Please refer to qualified electrical service or return to
the
nearest services centre if servicing is needed. This is a health care unit, not a washing
basin.
Clean feet before use and use clean and soft water. Deposits will clog air jets and undermine
the
bubble
effectiveness.
TO CLEAN: After use, simply rinse out with water. Never immerse the entire unit into water. If
you
wish, you can wipe off all surfaces with a damp cloth and a mild detergent, then rinse and
dry.
TO STORE: Be sure the unit is unplugged, cooled and emptied of water. Then store it in a clean
and
dry place. Before storage wind the whole power cord around the wiring holder. Never hang the
unit
by
the power
cord.
HOW TO USE THE MASSAGER:
The appliance must be operated with
water.
Check the rotary switch is in OFF or “0” position. Then plug the power cord into an AC
outlet
(regular household
current).
DO NOT CONNECT OR DISCONNECT THE PLUG FROM THE POWER OUTLET WHILE
YOUR
FEET ARE IN THE WATER.
Seat yourself comfortably, place your feet on the foot rests and select your desired setting for
heat
only, massage only, or heat and
massage.
USING THE CONTROL SWITCH TO SELECT THE DESIRED APPLICATION:
COLD WATER MASSAGE
(M)
This setting will massage your feet in cold
water.
WARMTH AND MASSAGE
(W+A+M)
Choose this setting and fill with warm water for a foot massage and bubble bath. The built-in
heater
delays temperature drop of the warm water while
bathing.
WARMTH
(W+A)
Warm water footbath with bubbles. Ideal for a footbath or for allowing stimulation from
previous
massage appliances to gradually
subside.
OFF
(O)
Turn the unit
off.
You can place your feet on the massage ball base situated on the central part of the unit or on
the
detachable massage rollers for partial massage whenever you
like.
When you are finished with the massager, just rotate the switch to OFF or “0” position.
Then
remove your feet and unplug the
unit.
REMEMBER NOT TO STAND ON THE
UNIT.
To Next Page
Loading...