PLUG REPLACEMENT (UK and Ireland only)
This appliance may be fitted with a non-rewirable plug. If you need to change the fuse in a
non-
rewir
able plug, the fuse cover must be refitted. If the fuse cover is lost or damaged, the plug must not
be
used until a replacement is obtained (available from the appliance
manufacturer).
If the plug has to be changed because it is not suitable for your socket, or becomes damaged,
it
should be cut off and appropriate plug fitted following the wiring instructions. The plug removed
must
be disposed of safely as insertion into a mains socket is likely to cause an electrical
hazard.
This equipment must be disconnected from the mains when not in use. Do not allow this unit to
be
exposed to rain or
moisture.
For your own safety read the following instructions carefully before attempting to connect this unit
to
the mains. You should only plug the appliance into a AC220-240V
~
50Hz supply. Connecting it
to
other power sources may damage the
appliance.
BLUE TO
E
L
FUSE
The wires in this mains lead are coloured
in
accordance with the following
code:
NEUTRAL
BROWN
N
IMPORTANT
TO LIVE
CORD
GRIP
BLUE =
NEUTRAL
BROWN =
LIVE
The colours of the wires in the mains lead of this appliance may not correspond with the
coloured
markings identifying the terminals in your plug proceed as
follows:
Caution
To prevent electric shock disconnect
from
the mains before removing the
cover
The blue wire must be connected to the terminal marked with the letter N or coloured
black.
The brown wire must be connected to the terminal marked with the letter L or coloured
red.
If a 3 Amp (BS1363) fused plug is used it must be fitted with a 3A fuse conforming to BS1362
and
be ASTA
approved.
If in doubt contact a qualified
electrician
DISPOSAL
INFORMATION
Waste electrical products should not be disposed of with household waste.
Please
recycle where facilities exist. Check with your local authority for recycling
advice.
7
To Next Page
Loading...