Visonic POWERMASTER 10 - Page 35

MENUS AND FUNCTIONS
34 D-303223 PowerMaster-10 / PowerMaster-30 User's Guide
Additional Information (section C.4)
1
For detailed instructions on how to select the setting options – refer to section B.1 and section B.2.
2
The display shows the 1
st
User Code (Master User) in the list of 8 User Codes (in PowerMaster-10
system) / 48 User Codes (in PowerMaster-30). If you have not yet changed the default code 1111, we
recommend that you change it now.
3
a. The display shows the user code currently programmed in this location (e.g. 5327).
b. The cursor blinks on the first digit of the code.
c. If the location is free the display will be blank ( - - - - ).
4
You can move the cursor to the next or previous digit using the ( / ) buttons. Pressing the
button erases the digit of the cursor + all digits right of the cursor.
5
a. The new code is momentarily displayed without the cursor before reverting to step 3.
b. If Partition is enabled, continue to step 6.
6
You can now repeat steps 3 - 5 to program or edit another user code. To end this session and to select
other menu options or to quit programming – follow the instructions in section B.2.
7
This setting can be performed only after completing steps 1 - 5 of section C.4A.
8
The

symbol now appears next to the newly selected Partitions.
9
You can now repeat steps 3 - 7 to program or edit another user code.