Visonic POWERMASTER 10 - Page 41

MENUS AND FUNCTIONS
40 D-303223 PowerMaster-10 / PowerMaster-30 User's Guide
C.7 Setting the Time & Time Format
♦ Here you can program or adjust the built-in-clock to show the correct time in the desired time format.
♦ You can select between a 24 hour and a 12 hour (AM/PM) time format.

Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see
table at end of this section.
A. To Set the Time Format
1.
Enter the USER SETTINGS menu and select the [TIME & FORMAT] option
and press the button to confirm.
1
2.
The display shows the currently selected time format.
2
or Click the or button until the display shows the desired time
format, for example, "EU FORMAT-24H" and press to confirm .
3.
B. To Set the Time
5
4.
At the blinking cursor position, enter the correct time, for example, “8:55A”,
us
ing
the numerical keypad
.
4
5.
When you are satisfied with the setting, press to confirm.
☺ Return to step 2
A "Happy Tune" ☺ sounds, the display reads the set time, returns to step
2 and then reads the selected time format.
6, 7
Additional Information (section C.7)
1
For detailed instructions on how to select User Settings – refer to section B.1 and section B.2.
2
a. The display shows the currently selected format (indicated by a

symbol), for example, " 24 Hrs ".
b. You can now select either the 12 Hrs or 24 Hrs time format using the or buttons.
3
The display shows the Time in the selected Time Format, for example, " 12:40 PM ", with the cursor
blinking on the first hour digit "1". The letter that follows the displayed time indicates one of the following:
"A" = AM; "P" = PM and "none" for 24 Hrs time format.
When the curser is positioned on the AM/PM digit, you can set to "AM" with the button and the
"PM" with the button
4
You can move the cursor to the next or previous digit using the or buttons.
5
This setting can be performed only after completing steps 1 – 3 of section C.7A.
6
The time saved is displayed without the cursor, for example, " 08:55 A " followed by the selected time
format.
7
You can now select another option in the User Setting menu (see section B.1 and section B.2), or quit
programming (see section B.3).
TIME
08
:55A
EU FORMAT
-
24H
TIME
1
2
:40P
US FORMAT
-
12H

TIME & FORMAT