Visonic POWERMASTER 10 - Page 42

MENUS AND FUNCTIONS
D-303223 PowerMaster-10 / PowerMaster-30 User's Guide 41
C.8 Setting the Date & Date Format
♦ Here you can program or adjust the built-in-calendar to show the correct date in the desired date format.
♦ You can select between a "mm/dd/yyyy" and a "dd/mm/yyyy" date format.

Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see
table at end of this section.
A. To Set the Date Format
1.
Enter the USER SETTINGS menu and select the [DATE & FORMAT] option
and press the button to confirm.
1
2.
The display shows the currently selected date format.
2
or
Click the or button until the display reads the desired date
format, for example, "DD /MM/YYYY" and press to confirm.
3.
B. To Set the Date
7
4.
At the blinking cursor position, enter the correct date, for example,
“
20.04.2011
”
,
us
ing
the numerical keypad
.
3, 4, 5
5.
When you are satisfied with the setting, press to confirm.
☺ Return to step 2
A "Happy Tune" ☺ sounds, the display shows the set date and returns to
step 2 and shows the selected date format.
6
Additional Information (section C.8)
1
For detailed instructions on how to select User Settings – refer to section B.1 and section B.2.
2
The display shows the currently selected format (indicated by a

symbol), for example, "mm/dd/yyyy".
You can now select either the "mm/dd/yyyy" or "dd/mm/yyyy" date format using the or
button.
3
The display shows the Date and selected Date Format, for example, " 30.12.2007 ", with the cursor
blinking on the first digit.
4
You can move the cursor to the next or previous digit using the or button.
5
For the year, enter the two last digits only.
6
You can now select another option in the User Setting menu (see section B.1 and section B.2), or quit
programming (see section B.3).
7
This setting can be performed only after completing steps 1 – 3 of section C.8A.
DATE DD/MM/YYYY
Date:
2
0/
04
/20
11
DATE 20/02/2008
DATE MM/DD/YYYY

DATE & FORMAT